Technical Data - Cristec SOLO Série Manuel D'utilisation Et De Montage

Technical data

Model SOLO
Input voltage (Unom) [V]
Nominal power [W]
« Standby » current [mA]
Power « ON » no load [W]
Maximum efficiency [%]
Length L x 124 (H) x 215 (W) [mm]
Weight [kg] Weight [kg]
Input voltage
Dynamic correction of Umin.
Output voltage
Distortion
Dynamic behaviour
Frequency
Charge detection (standby)
Maximum power 15 min
Maximum power 3 min
Peak power 5s
Asymmetric load
Cos ϕ
Protections
IP protection index
Forced ventilation
Overheating protection
Required battery capacity
Acoustic level
EEC conformity
Other specifications on request (Ex: 115V/60Hz).
These data are for information only and may change without notice.
SOLO3DEE
24V 2300W
48V 1200W
48V 2300W
48 24V/48
1200
12
4.8
95
391
13.2
Min. - Max.: < Unom x 0.95 to Unom x 1.33
- 10% at Pnom
True sine 230 Vac ±3%
< 2% (at Pnom)
From 0% to 100% load change. Normalisation: 0.5 ms
50 Hz ±0.01% (Crystal control)
Adjustable: 0.3 → 20 W
1.3 – 1.6 x Pnom / 25°C
1.6 – 2 x Pnom / 25°C
3.5 x Pnom
Up to 2 x Pnom
0.1 – 1
Overload/Overheat/Short-circuit/Reverse polarity by internal fuse
IP 20 complies with DIN 40050/IP 23 with top cover
From 45°C ± 3°C
75°C ± 3°C
> 5x Pnom/Unom (recommended value)
Without ventilation: < 10 dB
EN50081 I/II, EN 55014 - EN 55022, EN 61000-3-2
IEC 801 I/II/III/IV, CEI 555, IEC 1000-3-2, LVD 73/23/EEC
24V 3300W
24
2300 3300
25/17 25
9 13
95 95
591 636
26 30
With ventilation:< 35 dB
30015978
48V 3500W
48
3500
30
17
95
791
31
15