Conceptronic C300BRS4 Guide D'installation Rapide page 27

ENGLISH
2. The C300BRS4 Explained
• Front Panel
Nr Description
1 Power LED
2 Status LED
3 WAN LED
4 WLAN LED
5 LAN LED's
(1,2,3,4)
6 WPS LED
7 WPS Button
* In normal use, the Status LED will turn on and blink within 45 seconds after the device is turned on
or restarted. When a system failure happens with the device, the Status LED will not turn on.
You can use the following options to solve the system failure:
a. Power down the device, wait 10 seconds and reconnect the power to the device.
b. Reset the device to factory defaults by pressing the reset button on the back of the device for
+/- 15 seconds.
If the Status LED does not turn on after you tried above options, please contact Conceptronic
Support at: support@conceptronic.net
** For more information about the WPS feature, see Chapter 6 of this Guick Installation Guide.
7 6
Status Status Explanation
OFF The device is turned off
ON The device is turned on
OFF The device is turned off / System Failure*
BLINK The device is turned on and ready for use
OFF No WAN Connection is created
ON - STEADY A WAN Connection is created
ON - BLINK Data is sent or received through the WAN Port
OFF Wireless interface is disabled
BLINK Wireless interface enabled and active
OFF No Network Link is created to the LAN Port
ON - STEADY A Network Link is created on the LAN Port
ON - BLINK Data is sent or received through the LAN Port
ON – BLINK When the WPS Button is pressed, the WPS LED will blink for
120 seconds while searching for WPS Clients. **
Press the WPS Button to activate the WPS feature. The
router will search for WS Clients for 120 seconds. **
4
5
27
3 2 1