PVG R 25x-TC Série Manuel D'utilisation page 62

1 1 2 2 a a
1 1 3 3 a a
1 1 4 4 a a
1 1 5 5
100 cm
20 cm
50 cm 50 cm
1 1 7 7 a a
150 cm
50 cm
1 1 8 8 a a
1 1 8 8 c c
1 1 9 9 b b
Install the wick to the wick sleeve according to the allo-
12
1 1 2 2 b b
wed direction engraved on the wick sleeve.
Install the wick sleeve (with wick) to the primary air
13
tube. And then install the top of the stem into the
groove of the wick sleeve (with wick) from right side,
and left the stem to the end.
1 1 3 3 b b
14 Install the bracket. Then tighten the screw which is hol-
ding the stem.
Put the wick holder chassis back into position.
15
1 1 4 4 b b
Screw the four wing nuts hand tight.
16
Place the knurled wick adjustment knob on the wick
17
mechanism. Turn the knob as far to the right as possi-
ble. Press the tip-over switch. Check that the wick can
be lowered completely. Repeat this check a number of
1 1 6 6
times. If the wick cannot be lowered completely it has
not been placed correctly. If this is the case, repeat the
procedure from No. 12.
18 Put the cabinet back into position and tighten the three
screws. Put the knurled wick adjustment knob back into
position. Now put the combustion chamber back into
1 1 7 7 b b
position. Check that it is level by sliding it slightly to the
left and the right by its handle. Close the grill.
Put the filled removable tank into position. Put the bat-
19
teries into the battery holder (ensure that the positive
and negative poles match the + and – marks indicated
1 1 8 8 b b
on the battery housing). Wait 30 minutes after repla-
cing the tank and batteries before using the heater.
1 1 9 9 a a
4
61