Behaviour After Power Recovery; Maintenance And Cleaning; General Information About Radio Operation - HomeMatic HM-ES-PMSw1-PI Mode D'emploi

Actionneur de commutation sans fil à 1 canal avec mesure de la puissance, adapta teur

Table des Matières

Les langues disponibles

Behaviour after power recovery

After the device has been inserted to a socket or after power recovery the

switch actuator performs a self-test/restart (approx. 2 seconds). The de-

vice LED flashes red, green and orange briefly (LED test display). The

device LED will flash if an error is detected during this check (see sec. „8.1

Flash codes" on page 36). This is repeated continuously and the device

does not perform its function.

If the test is completed without errors, the switch actuator transmits a wire-

less telegram containing its status information. To prevent all HomeMatic

actuators from transmitting at the same time when power is recovered (af-

ter a mains power failure or a disconnection, for example), there is a ran-

dom delay before the switch actuator transmits. During this time, the device

LED slowly flashes orange. If the delay is very short, this flashing may be

almost imperceptible.

The product does not require any maintenance. Enlist the help of an ex-

pert to carry out any repairs. Clean the product using a soft, lint-free cloth

that is clean and dry. You may dampen the cloth a little with lukewarm

water in order to remove more stubborn marks. Do not use any deter-

gents containing solvents, as they could corrode the plastic housing and

label.

General information about radio

operation

Radio transmission is performed on a non-exclusive transmission path,

which means that there is a possibility of interference occurring. Interfer-

ence can also be caused by switching operations, electrical motors or

defective electrical devices.

Table des Matières

Table des Matières

Hm-es-pmsw1-pl