Teaching-In Directly In To Homematic Devices - HomeMatic HM-ES-PMSw1-PI Mode D'emploi

Start-up
Direct device connections between the switch actuator and
other HomeMatic devices can be made only with the switching
channel (see sec. „5.2.1 Teaching-in directly in to HomeMatic
devices" on page 30). Connections with the measuring
channel must be made via the CCU or the configuration adapter
(see sec. „5.2.2 Teaching-in to a HomeMatic Central Control
Unit" on page 31).
5.2.1

Teaching-in directly in to HomeMatic devices

If you want to teach-in the switch actuator to one or more HomeMatic de-
vices, the teach-in mode of both devices has to be activated first. To do
this, proceed as follows:
During teach-in, please make sure you maintain a distance of at
least 50 cm between the devices.
Activate the teach-in mode of your switch actuator with power metering.
Therefore, press and hold the channel button (A) for at least 4
•
seconds. The device LED (B) will slowly flash orange to indicate
that teach-in mode is active. The teach-in time is 20 seconds.
30
> 4 s