GE GIE21 Serie Manuel Du Propriétaire Et Instructions D'installation page 15

INSTALLING THE WATER LINE (Continued)
9 CONNECT THE TUBING TO
THE REFRIGERATOR
has an access cover,
remove it.
Remove the plastic flexible cap
from the water valve (refrigerator
connection).
Place the compression nut and
ferrule (sleeve) onto the end
of the tubing as shown. On SmartConnect™
Refrigerator Tubing kit, the nuts are already
assembled to the tubing.
connection as far as possible. While holding the
tubing, tighten the fitting.
Refrigerator Tubing kit, insert the molded end of
the tubing into the refrigerator connection and
tighten compression nut until it is hand tight,
then tighten one additional turn with a wrench.
Overtightening may cause leaks.
hold it in a vertical position. You may need to pry
open the clamp.
WARNING
HAZARD
NOT drill into the refrigerator.
Tubing
Clamp
1/4"
Compression
Nut
(sleeve)
Refrigerator
Connection
49-1000636-1
Installation Instructions
(CONT.)
ELECTRICAL SHOCK
1/4" Tubing
SmartConnect ™
Tubing
TURN THE WATER ON AT THE
10
SHUTOFF VALVE
Tighten any connections
that leak.
has an access cover,
reattach it.
INSTALLING THE
11
REFRIGERATOR
Plug in the refrigerator.
Arrange the coil of
tubing so that it does
not vibrate against the
back of the refrigerator
or against the wall.
Push the refrigerator
back to the wall.
START THE ICEMAKER
12
Set the icemaker power switch to the ON
position. The icemaker will not begin to operate
until it reaches its operating temperature
operation automatically if the icemaker power
switch is in the ON position.
15