Publicité
The operation of any tiller can result in foreign objects thrown into the eyes, which can result
in severe eye damage. Always wear safety glasses or eye shields before starting your tiller
and while tilling. We recommend a wide vision safety mask for over spectacles or standard
safety glasses.
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and oil
or attempting to start engine.
STOPPING (See Fig. 5)
TINES
•
Release forward tine control to stop forward move-
ment.
•
Release reverse tine control to stop reverse move-
ment.
ENGINE
•
Move throttle control to "STOP" position.
•
Never use choke to stop engine.
REVERSE
CONTROL
CHOKE
CONTROL
TINE OPERATION (See Fig. 5)
FORWARD
•
Squeeze forward tine control to handle.
REVERSE
•
With forward tine control "OFF" (up) position, pull back
and hold reverse tine control.
OPERATION
FORWARD TINE CON TROL IN
"OFF " (UP) POSITION
FORWARD TINE CON TROL
IN "ON" (DOWN) POSITION
THROTTLE
CONTROL
FIG. 5
TILLING
The speed and depth of tilling is regulated by the position
of the depth stake and wheel height.
The depth stake should always be below the wheels for
digging. It serves as a brake to slow the tiller's forward
motion to enable the tines to penetrate the ground. Also,
the more the depth stake is lowered into the ground the
deeper the tines will dig.
DEPTH STAKE (See Fig. 6)
Adjust depth stake by removing the hairpin clip and clevis
pin. Change depth stake to desired position. Replace the
clevis pin and hairpin clip.
•
For normal tilling, set depth stake at the second or third
hole from the top.
WHEELS (See Fig. 6)
Adjust wheels by removing the hairpin clip and clevis pin.
Change wheel position. Replace the hairpin clip and clevis
pin.
•
For normal tilling, set wheels at the second or third
hole from the top.
STAKE
SPRING
WHEEL
7
HAIRPIN CLIP
AND CLEVIS PIN
DEPTH
STAKE
FIG. 6
Publicité
