Publicité
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
CAUTION:
sta ples when handling or disposing
of cartoning material.
IMPORTANT:
WHEN UNPACKING AND AS SEM BLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
•
Cut cable ties securing handles.
•
Slowly lift handle as sem bly up, route cable(s) as shown
and align han dle holes with handle panel hole and
slot.
•
Loosely assemble hardware as shown. Be sure the
shorter (1" long) hex bolt is assembled in lower hole of
handle. Repeat for opposite side. Tight en all hard-
ware se cure ly.
•
Cut cable ties securing tiller to skid and remove tiller
from skid.
•
Remove screws securing depth stake to skid and dis-
card the screws.
NUT
HAN DLE
PANEL
CABLE(S)
TILLER
HANDLES
ASSEMBLY
Be careful of exposed
LOCK
TILLER
WASH ER
HANDLE
HEX BOLT
FLAT
5/16-18X1-1/4"
WASHER
HEX BOLT
5/16-18X1"
HANDLE
PANEL
BOLTS
FIG. 2
INSTALL DEPTH STAKE AS SEM BLY
(See Fig. 3)
•
Loosen nut "A".
•
Insert stake support between engine brack et halves
with stake spring down.
•
Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tight en se curely. Tighten nut "A".
•
Depth stake must move freely. If it does not, loosen
support bolt.
HANDLE HEIGHT
•
Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Ad just -
ments section of this manual).
TILLING WIDTH
•
Tilling width may be adjusted to better handle your
tilling con di tions (See "TINE ARRANGEMENT" in the
Service and Adjustments section of this manual).
TINE OPERATION
•
Check tine operation before fi rst use. (See "TINE OP-
ERATION CHECK" in the Service and Adjustments
section of this manual).
5
ENGINE BRACK ET
HALVES
NUT "A"
DEPTH STAKE
SUPPORT
STAKE
SPRING
HEX BOLTS,
LOCK WASH ERS,
AND HEX NUTS
FIG. 3
DEPTH
STAKE
SUPPORT
BOLT
Publicité
