Publicité
TROUBLESHOOTING POINTS
PROBLEM
Will not start
Hard to start
Loss of power
10.
12.
13.
Engine overheats
Excessive bounce/
diffi cult handling
Soil balls up or clumps
Engine runs but tiller
won't move
Engine runs but labors
when tilling
CAUSE
1.
Out of fuel.
2.
Engine not "CHOKED" properly.
3.
Engine fl ooded.
4.
Dirty air cleaner.
5.
Water in fuel.
6.
Clogged fuel tank.
7.
Loose spark plug wire.
8.
Bad spark plug or improper gap.
9.
Carburetor out of adjustment.
1.
Throttle control not set properly.
2.
Dirty air cleaner.
3.
Bad spark plug or improper gap.
4.
Stale or dirty fuel.
5.
Loose spark plug wire.
6.
Carburetor out of adjustment.
1.
Engine is overloaded.
2.
Dirty air cleaner.
3.
Low oil level/dirty oil.
4.
Faulty spark plug.
5.
Oil in fuel.
6.
Stale or dirty fuel.
7.
Water in fuel.
8.
Clogged fuel tank.
9.
Spark plug wire loose.
Dirty engine air screen.
11.
Dirty/clogged muffl er.
Carburetor out of adjustment.
Poor compression.
1.
Low oil level/dirty oil.
2.
Dirty engine air screen.
3.
Dirty engine.
4.
Partially plugged muffl er.
5.
Improper carburetor adjustment.
1.
Ground too dry and hard.
2.
Wheels and depth stake incorrectly adjusted.
1.
Ground too wet.
1.
Tine control is not engaged.
2.
V-belt not correctly adjusted.
3.
V-belt is off pulley(s).
1.
Tilling too deep.
2.
Throttle control not properly adjusted.
3.
Carburetor out of adjustment.
CORRECTION
1.
Fill fuel tank.
2.
See "TO START ENGINE" in the Operation section.
3.
Wait several minutes before attempting to start.
4.
Clean or replace air cleaner cartridge.
5.
Empty fuel tank and carburetor, and refi ll tank with
fresh gasoline.
6.
Remove fuel tank and clean.
7.
Make sure spark plug wire is seated properly on
plug.
8.
Replace spark plug or adjust gap.
9.
Make necessary adjustments.
1.
Place throttle control in "FAST" position.
2.
Clean or replace air cleaner cartridge.
3.
Replace spark plug or adjust gap.
4.
Empty fuel tank and refi ll with fresh gasoline.
5.
Make sure spark plug wire is seated properly on
plug.
6.
Make necessary adjustments.
1.
Set depth stake and wheels for shallower tilling.
2.
Clean or replace air cleaner cartridge.
3.
Check oil level/change oil.
4.
Clean and regap or change spark plug.
5.
Empty and clean fuel tank and refi ll, and clean
carburetor.
6.
Empty fuel tank and refi ll with fresh gasoline.
7.
Empty fuel tank and carburetor, and refi ll tank with
fresh gasoline.
8.
Remove fuel tank and clean.
9.
Connect and tighten spark plug wire.
10.
Clean engine air screen.
11.
Clean/replace muffl er.
12.
Make necessary adjustments.
13.
Contact an authorized service center/department.
1.
Check oil level/change oil.
2.
Clean engine air screen.
3.
Clean cylinder fi ns, air screen, muffl er area.
4.
Remove and clean muffl er.
5.
Adjust carburetor to richer position.
1.
Moisten ground or wait for more favorable soil
conditions.
2.
Adjust wheels and depth stake.
1.
Wait for more favorable soil conditions.
1.
Engage tine control.
2.
Inspect/adjust V-belt.
3.
Inspect V-belt.
1.
Set depth stake for shallower tilling.
2.
Check throttle control setting.
3.
Make necessary adjustments.
16
Publicité
