Makita M9002 Manuel D'instructions page 6

FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Shaft lock
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
1
015066
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
015067
For tool without lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For tool with lock button
CAUTION:
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
1. Shaft lock
1. Lock button
1
2. Switch trigger
2
To stop the tool from the locked position, pull the switch
trigger fully, and then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
015068
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel/Multi disc)
CAUTION:
When using
•
wheel/Multi-disc, the wheel guard must be fitted on
the tool so that the closed side of the guard always
points toward the operator.
3
015069
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard to such an angle that it can
protect the operator according to work. Be sure to
tighten the screw securely.
To remove wheel
procedure in reverse.
6
a depressed center
1. Wheel guard
1
2. Screw
3. Bearing box
2
guard, follow the
grinding
installation