Yamaha TX-592RDS Mode D'emploi page 10

MANUAL PRESET TUNING
This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only
selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored.
To store stations
1
Tune in to a desired station.
(Refer to the previous page for tuning procedure.)
2
Select a desired group (A – E) of preset stations
confirming it on the display.
A/B/C/D/E
3
MEMORY
MAN'L/AUTO FM
4
Select a preset station number where you want to
program the station before the "MEMO" indicator goes
off from the display.
1
5
Shows the displayed station has been
programmed to A1.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to preset station numbers
on other groups in the same way by selecting other groups
in step 2.
10
PRESET TUNING
NATURAL SOUND
AM/FM STEREO TUNER TX–592RDS
STANDBY/ON
MEMO
Flashes on and off
for about 5 seconds.
PRESET STATIONS
2 3 4
6 7 8
AUTO ST
MHz
4, 2 2
PRESET STATIONS
1 2 3
5 6 7
RDS MODE/FREQ PTY SEEK EON A/B/C/D/E MEMORY EDIT FM/AM
MODE START MAN'L/AUTO FM
2, 1 1 3
To recall a preset station
1 1
Select the group of preset stations.
A/B/C/D/E
2 2
Select the preset station number.
Notes
•
A new setting can be programmed in place of the former
one.
•
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if this unit is turned into the standby
mode or the power plug is disconnected from the AC outlet or
the power is cut due to temporary power failure. If, however,
the power is cut for more than one week, the memory may be
erased. If so, it can be re-programmed by simply following
the PRESET TUNING steps.
TUNING
4
8
TUNING MODE PTY SELECTOR
AUTO/MAN'L MONO
PRESET STATIONS
1 2 3 4
5 6 7 8