Hoover H-WASH 550 H5WPB4 47AMBC8-S Mode D'emploi page 63

2. INSTALLATION
Remove the 2 or 4 transportation

screws (A) on the back and
remove the 2 or 4 flat washers,
rubber bungs and plastic spacer
tubes (B) as illustrated in figure 1.
If the washing machine is built-

in, unscrew
transportation screws (A) and
remove the 3 or 4 flat washers,
rubber bungs and plastic spacer
tubes (B).
During the removal of the screws

occasionally spacer tubes fall
inside the product, these can be
remove by tilting the product forward
and recovering them from the floor
or inside the base of the machine.
Cover the open transportation screw

holes with the 2 or 4 plastic caps
included in the instruction bag.
WARNING:
keep packaging
away from children.
Place the corrugated plastic

sheet, found on top of the
appliance during the unpacking
*
process , into the base of the
appliance as shown in figure 2
(according
consider version A, B or C).
*
In some models, the corrugated
plastic sheet is not provided.
the 3 or
materials
to the model,
4
63