Publicité
Les langues disponibles
Les langues disponibles
page 6
LAMP AIMING
With unit open, loosen the nut
1
and screw and aim the lamp
head to the desired position.
LAMP AIMING and WIRE DIAGRAM
With lamp heads aimed, begin by
2
tightening the nut until the gasket is
fully compressed.
(Torque spec: 12 in-lbs)
Gasket
WIRING DIAGRAM
Battery
Remote
Connector
Connector
Heater
AC input
Connector
Connector
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
3
Hex Nut
Nylon Washer
Screw
Lamphead
Connector
Status LED
Connector
Federal Communications Commission (FCC)
Requirements:
This device complies with FCC Title 47, Part 15, Subpart B.
This device does not cause harmful interference.
www.lithonia.com
With nut secure, tighten the screw to
finish aiming procedure.
(Torque spec: 10 in-lbs)
Part # 912-00031-001
© Acuity Brands Lighting, Inc. 2019
All Rights Reserved.
Rev. B, 5/2019
Publicité
