NSTRUCTION FOR USE
Attention!Before the fi rst use of the device you must remove protection foil from all surfaces and wash the
device with water with detergent. Than splash it with clean water. Use the device under supervision. Never
use the device without oil or if the level of the oil is lower then min. line - danger of fi re. If the oil is dirty or you
use the oil longer time it may cause boiling over.
Make sure the heating element is in its working position (pic. 1) after connecting the appliance to the mains.
If the heating element is positioned vertically, the appliance cannot be put into operation (pic. 2). Fill the
device with frying oil not higher than the line on the side. Turn the knob (A) to required position between 50°C
- 190°C. Pilot lamps (B) and (C) will light. Pilot lamp (B) lights when the device is in elektricity and switched
on. Pilot lamp (C) lights when the thermo spirals are on. Pilot lamp (C) goes out when the device reaches
required temperature. Switch the device off by turning the knob (A) into position „0".
Comments and recommendation
You must always check the level of oil, never use the device without oil. Use the device only under supervision.
B
A
C
Access to safety thermostat
B
C
A
pic. 1
pic. 2
6