Wagan Tech 12V Roadside Impact Wrench Guide D'utilisation page 7

• Prevent oil or oil products from entering the plastic casing. The chemicals
they contain could corrode or damage the plastic. Grease and oil-based
grime must be immediately wiped off the tool and accessories with a
slightly damp cloth.
• Store idle power tools out of reach of children and do not allow people
unfamiliar with the power tool or these instructions operate it. Power tools
are dangerous in the hands of untrained users.
• Disposal of this product should only be done in accordance with the current
regulations.
REPLACING THE FUSE IN THE 12V DC PLUG
1. Twist off the upper cover of the 12V DC plug.
2. Remove the faulty fuse.
3. Insert a new fuse of the same type (a spare fuse is included in the case)
4. Twist the cover back onto the plug.
TROUBLESHOOTING
Problem
The impact wrench will not start
A wheel nut cannot be unscrewed or
tightened
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2019 Wagan Corporation. All Rights Reserved.
Possible Solution
Check if the vehicle battery is dead
Check if the 12V socket is faulty
Check the fuse in the 12V DC plug of
the wrench
Check that the correct rotation
direction has been selected
6