Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS
Voltage
Power Draw
Max Torque
Cable Length
Fuse Rating
Square Drive Anvil
Included Socket Diameters
OPERATION
Start the engine before operating the wrench. Keep the engine running while
using. Unplug impact wrench from 12V DC socket when not in use.
Switch operation
•
For loosening lug nuts, press the side of the switch marked "L"
•
For tightening lug nuts, press the side of the switch marked "T"
•
To power off, simply release the switch
•
IMPORTANT: After tightening with the wrench, it is important to check the
specified torque by using a torque wrench. Consult your vehicle's manual
for recommended torque specifications.
Loosen Lug Nuts
•
Use your jack to lift up your car and ensure there is about 2 inches (5 cm)
between the tire and the ground
•
Refer to your car's operation manual for the recommended lifting
point and safe operations
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2019 Wagan Corporation. All Rights Reserved.
12V DC
150 Watts
258 ft-lb
9.5 ft (2.9 m)
15A, 250V
1/2" (12.7 mm)
17/19 mm, 21/23 mm
4
Publicité
Table des Matières
