Publicité
Les langues disponibles
Les langues disponibles
EN
Attention: Risk of tool damage.
• The tool is not filled with motor or gearbox oil from the factory. Before operation, the fuel tank must be filled.
• Use a mixture of synthetic two-stroke motor oil and unleaded gasoline. Add 30 ml of oil per litre of gasoline.
• Never use oil made for 4-stroke or water-cooled 2-stroke engines as this can cause spark plug fouling, exhaust port blocking or piston ring sticking.
• Mixed fuel, which has been left unused in the fuel tank for a period of one month or more may clog the carburetor or result in the engine failing to operate
properly. Fill up airtight containers with old fuel and keep them in a dark and cool room.
Warning: Fire hazard.
• Always shut off the engine and wait for it to cool down before filling the fuel tank.
1. Unscrew the fuel tank cap and remove it. (Fig. 20-21)
2. Pour in the fuel carefully. Avoid spilling. (Fig. 22)
3. Screw the fuel tank cap back on firmly by hand.
Draining the fuel tank
1. Hold a container beneath the fuel tank cap.
2. Unscrew the fuel tank cap and remove it. (Fig. 20-21)
3. Allow the fuel tank to empty completely.
4. Screw the fuel tank cap back on firmly by hand.
Fig. 20
PRE-OPERATION CHECK
Warning:
• Do not start the unit until it has been completely assembled.
• Always check the unit before operation to ensure that no part is damaged or defective. If a part is damaged or defective, make sure to replace it before
using the tool.
• Before operation, always check the ground and remove all objects which could be thrown by the tool.
Carry out the following checks before starting the engine:
• Check the tool for leaks.
• Check the tool for visual defects.
• Check that all parts of the tool have been securely fitted.
• Check that all safety devices are in proper condition.
OPERATING INSTRUCTIONS
Starting the engine
1. Press the fuel primer bulb more than 5 times. (Fig. 23)
2. Turn the engine switch (1) to the ON position. (Fig. 24)
3. Set the choke lever to the OFF position. (Fig. 25-26)
4. Pull the recoil starter handle to start the engine. (Fig. 27)
5. Wait for a short while and then set the choke lever to the ON position.
1
Fig. 24
6
Fig. 21
Fig. 25
WWW.NIKOLAOUTOOLS.GR
Fig. 26
Fig. 22
Fig. 23
Fig. 27
Publicité
