Fitting The Remote Control Panel; Safety Devices - Techno Block WP Série Notice De Mode D'emploi Et D'entretien

6.6 Fitting the remote panel :
Remove the side screws and lift the front cover.
Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in a vertical position.
Close the panel by remounting the cover. Fit the connecting cable between panel and unit making sure not to
bundle it with other cables.
ATTENTION
Check that the unit and its devices have suffered no damages during transport. Pay
special attention to the componentssecured to the electric panel door and to the
refrigerating circuit pipes. Mount the unit as shown in the drawings; make sure that
the
electric connections are carried out properly.
6.7

Safety devices

mechanical safety devices
The following
1. Fixed upper and side protections for evaporator and condensing unit, secured by locking screws.
2. External fan protections placed on the evaporating and condensing units, secured with screws.
electrical safety devices
The following
a. Protection of fans (belonging to motors) against high power absorption; with automatic reset.
b. High pressure switch (only for special components) to protect against excessive pressure; with
automatic reset.
WARNING
Above devices have been developed to safeguard the operator's safety.
are supplied:
are supplied:
2
1
1