Bimar E006-12 Notice D'instructions page 10

INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure, do
not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality. The bag
containing the feet, which is unmarked due to its small size, therefore you have to follow the
procedures for the disposal of their municipality.
Warning: the fan should be used only with the
feet attached to the base.To fix each foot (right
and left), insert it all the way into the
appropriate seat on the lower part (base), in the
correct direction (the longer part of the foot
must be in the back)
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility between
the electric outlet and the plug of the heater, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the heater. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must not be less
that the maximum of the applian ce.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2
meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
• Do not use the appliance with a timer or a programmer or with a system that can switch on
the appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered
or positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane
(the appliance could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
USE INSTRUCTIONS
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
10