Comfee MDDN-10DEN7 Manuel D'utilisation page 81

Removing the collected water
2. Continuous draining
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
(not included).
Remove the rubber plug from the back drain
hose outlet. Attach a drain hose(ID=13.5mm)
and lead it to the floor drain or a suitable
drainage facility(see Fig.8 and Fig.9).
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain,making sure that
there are no kinks that will stop the warter flowing.
Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow
smoothly. Donever let it up.
Make sure the water hose is lower than the drain hose
outlet.
Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
Remove the cover
NOTE: When the continuous drain feature is not
being used,remove the drain hose from the outlet
and attach the rubber plug back to the drain outlet
.
Fig. 8
15
OPERATING THE UNIT
Drain hose
Fig. 9