Publicité
Les langues disponibles
Les langues disponibles
4. Place the gasket ("O-RING") (C) on the lower base (B).
5. Lift the upper stand (A) onto the lower stand (B). Connect the hoses.
6. Turn the locking ring clockwise to connect the two stands (A + B). The handle and the shower
head (D) must point in the same direction.
3.3.
Device use
INITIAL SETTING OF THE SOLAR SHOWER
1. Open the handle and turn it to the "hot" position. This will ensure that no air bubbles are trapped
in the hoses when filling with water.
2. Connect the garden hose to the hose connector (J). Turn on the water to fill the solar shower. It
will take a few minutes to fill the solar shower.
3. When the water flows out of the shower handset (D) turn off the handle. The solar shower now
starts to heat the water.
4. Depending on the available sunlight and the outside temperature, it will take several hours for
the solar shower to fully heat the water.
5. In strong sunlight, the water temperature of the solar shower can reach up to 60°C.
WARNING: To avoid scalding, set the handle to the "cold" water position before using the solar shower.
Then set the desired temperature.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive cleaners to clean the surface.
b)
The device must be regularly inspected to check its technical efficiency and spot any damage.
c)
Use a soft, damp cloth for cleaning.
d)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
e)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
f)
f) WINTERING
•
Turn off the water and disconnect the garden hose.
•
Open the handle and turn it to the "hot" position to drain the water from the hoses and solar
shower (this takes a few minutes). Do not touch or rotate the handle when emptying, otherwise
water will stop flowing.
Turn the locking ring counterclockwise to unscrew the upper stand (A) from the lower stand (B).
•
Then disconnect the hose connection. Now water will flow from the shower.
•
Remove the lower stand (B) and pour out the remaining water.
Clean and dry all parts of the solar shower.
•
•
In winter, store all parts of the solar shower indoors and in a dry place.
g) NOTE:
•
Do not use salt or other antifreeze agents.
Recommended water pressure: maximum 3.5 bar. Under no circumstances should a solar shower
•
be powered by an additional pump or domestic water source.
•
Heating water causes it to expand. Thanks to this, water escapes from the shower head to a
minimal extent.
•
When using the shower for the first time, to get rid of the plastic and oil smell, wait a few minutes
for the water to drain and then clean the internal parts of the shower under running water.
EN
Publicité
