Meec tools 011638 Mode D'emploi page 24

EN
REDUCTION OF NOISE AND
VIBRATIONS
• Plan the work so that exposure to heavy
vibrations is spread over a longer period.
• To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
• Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
– Only use the tool in accordance with
these instructions.
– Check that the tool is in good condition.
– Use accessories in good condition, and
which are suitable for the purpose.
– Keep a firm grip on the handles/grips.
– Maintain and lubricate the tool in
accordance with these instructions.
SYMBOLS
Read the instructions.
Safety class II.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Rated output
Stroke rate
Percussion force
Tool holder
Weight
24
230 V ~ 50 Hz
1300 W
3450 rpm
15 J
SDS-Max
7 kg
Cord length
Sound pressure level, LpA
Sound power level ¹ 97,8 dB(A), K = 1.58 dB(A)
Sound power level ² 100 dB(A), K = 1.58 dB(A)
Vibration level ³ 21.788 m/s², K = 1.5 m/s²
¹) Measured, LwA
²) Guaranteed, LwA
³) ah, CHeq
Always wear ear protection.
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN IEC 62841-2-6:2020.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
1. Support handle
2. Crank arm cover
3. Power switch
4. Motor casing
5. Lock nut
FIG. 1
The product is supplied with the following
accessories:
• Flat chisel (18x320 mm)
• Pointed chisel (18x320 mm)
2 m
83.8 dB(A),
K = 1,58 dB(A)