Sebson AC SENSOR B Mode D'emploi page 9

Function test:
Ensure that the motion detector is not obscured. Ensure that the coverage area is not restricted by items such as
through large furniture. To set the detection range and the daylight test, turn the knobs to the positions shown. The
motion detector is activated after a warm-up phase of approx. 30s. If no further movement takes place in the
sensing area of the sensor, the sensor switches off.
Technical Data:
Operating voltage:
Maximum power consumption:
Electrical protection:
Protection class:
Detection moving speed:
Ambient temperature:
Humidity:
Possibilities of adjustments:
Detection area:
Sensitivity when switching (with regard to
the ambient brightness):
Time setting (switching off delay):
Information for private households (WEEE):
The Electrical and Electronic Equipment Act (WEEE) contains a large number of requirements for the handling of
electrical and electronic equipment. The most important ones are summarised here.
1. Separate collection of waste equipment
Old, worn-out or defective electrical and electronic equipment is referred to as waste equipment. These devices must
not be disposed of in the normal household waste or together with the residual waste. The devices should be
transferred to special collection and return systems.
2. Batteries and rechargeable batteries as well as illuminants
As a rule, owners of WEEE shall separate spent batteries and accumulators that are not enclosed in the WEEE, as
well as light sources that can be removed from the WEEE without causing damage, from the WEEE before handing
it over to a collection point. This does not apply if WEEE is prepared for reuse with the participation of a public waste
management authority.
220 -240V AC 50Hz
Max. 2.000W
Max. 1.000W
IP20
II
0,6-1,5m/s
-20° - +40°C
<93%
Max.2-9m (<24°C)/ 120°
<3-2.000LUX
Min. 10s +/- 3s - Max. 15min +/-2min
9