Publicité
Les langues disponibles
Les langues disponibles
Once the first channel to process of an input is added, that input gets configured in its corresponding
band (VHF or UHF), so channels of that band can be only added.
In the previous example, once added the input channel Ch21 for input 1, that input 1 only will allow
adding input channels of UHF band.
NOTE: To change the band used for an input, the user must remove all
channels of that input. Thus, all the channels of the two bands will be
enabled to configure the first filter.
1.5 Edit a channel
To change an input or output channel, place at that input channel list.
Once display the channel to edit, press the right arrow.
Change the input and output channel numbers and save again.
1.6 Delete a channel
To delete a channel, place at that input channel list.
The channel must be edited and must be configured with input channel in number Ch00.
Once the channel is saved, this will be removed.
2. FM Pre-Ampli
Allows enabling or disabling the internal FM pre-amplifier provided by the module.
3. Input
3.1 Auto Disable: Allows automatically disabling any activated channel while a minimum input level is
not detected, optimizing the quality of the output channels present.
4. Output
4.1 Output power. From 93 dBµV to 113 dBµV. The amplifier output power is referred to channel power,
and the more channels are added, the less output power must be set for each channel.
4.2 Slope. From 0 and 9 dB.
5. Set Country
In this menu, the channel and frequency list used in the channel conversion will be selected.
6. Set Language
In this menu, the language used by the module to show the texts in the LCD screen will be selected.
7. FW Version
This menu will show the hardware, MCU and software versions working in the module.
8. Reset default
Loads in the module a factory configuration, clearing permanently all the previous programming.
9. Lock
To avoid unauthorized people changing the settings or unintended handling, the module can be locked
with security code.
9.1 Set Pin Code. This option allows the user to change the pin code. Default pin code: 0000.
9.2 Lock. The pin code requirement will be enabled.
9.3 No Lock. The pin code requirement will be disabled.
10. LCD Timeout
By default, the display will turn off in 30 seconds if there's no user interaction.
This will be again switched on when the user presses any key.
The timeout can be modified in 30, 60, 90 or 120 seconds.
16
Publicité
