Publicité
Les langues disponibles
Les langues disponibles
1. Position trim kit frame over the opening so that the upper tabs
fit inside the rails, as shown.
2. To vertically center the trim kit frame, slide it upward, against
the opening, until the upper tabs catch against the top of the
rails.
3. Holding the trim kit frame firmly in place, use 7/64" drill to drill
four pilot holes into the front facing of the cutout/cabinet
through the mounting hole guides in the upper and lower
corners of the trim kit frame.
NOTES:
The holes will be drilled upward from the bottom, and
downward from the top at an angle of about 45°.
A. Mounting hole guide
B. 93# Screws (4 -
painted)
6
Install Trim Kit Frame
C. TK Frame
D. Cabinet
4. Secure trim kit frame to cutout/cabinet by installing four long
wood screws (painted) into the pilot holes drilled in Step 3
above.
NOTES:
To ensure vertical centering, install the lower screws first.
To avoid damage to the trim kit frame, do not overtighten
screws.
Installation is now complete. Replace any loose items that have
been removed from microwave oven cavity.
Save these Installation Instructions for future reference.
Publicité
