Husky H43FWB Guide D'utilisation Et D'entretien page 6

STEP 3:
DRILLING HOLES
When drilling into a wall stud, use a 7/32" drill bit, and drill approximately 2" deep.
NOTE: If any marked location is not over a stud, then use a 3/8" drill bit and install anchor(#14)
into hole by gently tapping with hammer.
1. Drill holes D1-D4 on left side.
2. Depending on the wall stud spacing determined in Step 1, drill four holes D5-
D8 on right-hand side that are either 24" or 32" (on center) from D1-D4.
3. Remove paper template from the wall.
14. Plastic Anchor
Use if Necessary
M
Tape Measure
Hammer
Level
Power Drill
Wall
(D1)
(D2)
(D3)
(D4)
6
(D5)
(D6)
(D7)
(D8)