Publicité
Les langues disponibles
Les langues disponibles
Assembly
A PAPER TEMPLATE IS INCLUDED IN THE PACKAGING FOR
PROPER MEASURING. REFER TO STEP 1-STEP 3 BELOW.
STEP 1:
WIDTH POSITIONING
CAUTION:
It is strongly recommended to screw at
least one side into wooden studs for proper support.
·
Determine stud location using a stud nder and measure
distance between studs.
o If distance between studs is 24", use inside holes at 24" width.
o If distance between studs is 16", use outside holes at 32"width.
o If distance between studs is neither 24" or 32", line one
side of workbench with stud and use the outside holes at 32".
·
If not utilizing studs at all then use outside holes at 32" width.
WALL
(D1)
(D2)
(D3)
(D4)
FLOOR
1''
STEP 2:
HEIGHT POSITIONING
1. Determine a comfortable height for your workbench
(typically between 37" - 45" from oor), and mark
location on wall where left-side screws will be placed.
Ensure the mark is located in the center of the wall stud.
2. Punch hole in included Paper Template at H1 mark.
Place template on the wall lining up H1 hole with mark
made on the wall.
3. Using a level, ensure that Marks D1-D4 are vertically
level, and Marks D2 and D6 are horizontally level.
4. Once all holes are lined up and level, secure Paper
Template to the wall with tape.
20''
5
Please contact 1-888-HD-HUSKY for further assistance.
32''
24''
M
Tape Measure
Stud Finder
Level
HUSKYTOOLS.COM
Publicité
