Publicité
14
1. Make sure the battery is fully charged before first use.
2. Plug the charging unit into a power supply socket and put the toothbrush handle onto
the charging unit.
3. A full charge takes about 24 hours and enables approximately up to 6 weeks brushing.
Once fully charged, the charging indicator shows the battery is full, as long as you keep
the toothbrush on the charging unit.
4. Pull charger unit plug out of power supply socket to save energy, or leave it in and keep
the brush on the charging unit (there is no risk of overcharging of battery).
1. Once the battery is fully charged, attach a brush head to the handle and apply tooth-
brush.
Note: there will be about 0,5 mm space between the brush head and the handle.
2. To avoid splashing, guide the brush-head to your teeth before switching the appliance
on.
3. Place the bristles against the teeth at a slight angle towards the gum line.
4. Press the power button to turn it on. If you keep pressing the power button, the device
EN
will enter next mode (the sequence is: power on in clean mode, white mode, polish
mode, massage mode, sensitive mode, power off ).
Please note: this toothbrush has a memory function; it powers on in the last selected
source. However, when powered on for the first time, by default it boots in clean mode.
Later on, the device boots in mode it has been used lately.
1. This device has been equipped with 2 minutes auto switch off function. This features
helps the user to maintain proper oral health care habits. Once the 2 minutes are up, the
toothbrush turns off automatically.
2. The toothbrush stops shortly every 30 seconds to remind user the passing time.
Tip: Use this feature to measure equal time for each tooth quadrant. This way you'll spend
30 seconds on each part.
Owner's manual
CHARGING
OPERATION
TIMER
Owner's manual
This device offers different brushing modes for varying oral care needs:
• Clean – Exceptional teeth cleaning; up to 31 000 strokes/minute
• White – removes surface stains, microscopic plaque and bacteria; up to 41 000 strokes/
minute
• Polish – removes 2x more plaque; up to 48 000 strokes/minute
• Massage – Gentle stimulation of gums, repetitive cycles of strong to weak strokes;
up to 31 000 strokes/minute
• Sensitive – Gentle, yet thorough cleaning for sensitive areas; up to 31 000 weak strokes/
minute
To turn the toothbrush on, press the power button once. If you keep pressing the power
button, the device will enter next mode. The sequence is:
• power on in clean mode
• white mode
• polish mode
• massage mode
• sensitive mode
• power off
Please note, you will only be able to change mode within 5 seconds from the last time you
pressed the button. Once the 5 seconds are up, the device stays in the chosen mode.
Please note, the device enters Clean mode automatically when powered on for the first
time.
According to selected work mode, one of the mode indicator will stay lit.
BRUSHING TECHNIQUE
1. Guide the brush head slowly from tooth to tooth.
2. Hold the brush head in place for a few seconds before moving on to the next tooth.
3. Brush the gums as well as the teeth. Start with the outside of the teeth, then the insides,
ending with the chewing surfaces.
4. Do not scrub or press hard, simply let the brush do all the work.
CLEANING
1. After brushing, rinse you brush head thoroughly under running water.
2. Remove the brush head from the handle and clean both parts separately under running
water. Then wipe them dry completely before you put the handle onto the charging
unit.
3. Before cleaning your charging unit, make sure you unplug the adaptor. Only use a dry or
damp-dry cloth to wipe the surface of the charging unit.
MODE
15
EN
Publicité
