Publicité
Les langues disponibles
Les langues disponibles
READ ME FIRST
LISEZ-MOI D'ABORD
Gas leak testing
Test de fuite de gaz
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
Il est important que le réchaud soit testé avant la première utilisation et chaque fois que la bombonne de gaz est
reconnected to the BBQ.
remplie et raccordée
To Complete Leak Test
Il est important que le réchaud soit testé avant la première utilisation et chaque fois que la bombonne de gaz
• Make sure all the control knobs are OFF.
est remplie et raccordée au réchaud. Comment effectuer le test de fuite.
• In a small container, mix up a solution of water and detergent/soap.
• Assurez-vous que tous les boutons soient sur OFF.
• Mix the solution well (about the same concentrate as washing up water).
• Mélangez l'eau et le produit de lavage / le savon dans un petit récipient.
• Turn the cylinder ON by rotating the knob to open position.
• Mélangez bien (environ la même concentration que pour l'eau de vaisselle).
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
• Tourner la molette de la bombonne de gaz en position ouverte.
- the gas connection at the inlet of the BBQ
• Utilisez une brosse ou un vaporisateur pour appliquer la solution savonneuse sur la conduite de gaz et le rac-
- all gas hose connections
cord individuel du tuyau à gaz. Notamment :
- the gas connection at the gas cylinder
- le raccord de gaz à l'entrée du réchaud
• If bubbles appear, there is a gas leak.
- tous les raccords de tuyaux de gaz,
• If the leak is at the connection, re-tighten and re-seal.
- le raccord de gaz au niveau de la bombonne.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Si des bulles apparaissent, il y a une fuite de gaz.
• Replace gas hose and regulator.
• Si la fuite se situe au niveau du tuyau, resserrez et assurez l'étanchéité.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• Si la fuite se situe ailleurs ou si vous ne pouvez pas réparer la fuite en serrant le raccord, NE CONTINUEZ
PAS.
• Remplacer le flexible de gaz et le régulateur.
• Les tuyaux et les régulateurs peuvent être achetés auprès de votre spécialiste Morsø local. Avec une pièce
originale de Morsø Jernstøberi A/S.
88
2
READ ME FIRST
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before first use and every time the gas
It is important that you leak test the BBQ before first use and every time the gas cylinder is refille
reconnected to the BBQ.
reconnected to the BBQ.
To Complete Leak Test
To Complete Leak Test
• Make sure all the control knobs are OFF.
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each joi
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line
- the gas connection at the inlet of the BBQ
- the gas connection at the inlet of the BBQ
- all gas hose connections
- all gas hose connections
- the gas connection at the gas cylinder
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the con
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NO
• Replace gas hose and regulator.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail spec
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
2
2
READ ME FIRST
READ ME FIRST
Gas leak testing
Gas leak testing
It is important that you leak test the BBQ before first use and ev
Gas leak testing
reconnected to the BBQ.
It is important that you leak test the BBQ before first use and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
To Complete Leak Test
• In a small container, mix up a solution of water and detergent/
• Make sure all the control knobs are OFF.
• Mix the solution well (about the same concentrate as washing
• In a small container, mix up a solution of water and deterge
• Turn the cylinder ON by rotating the knob to open position.
• Mix the solution well (about the same concentrate as wash
• Using a brush or spay bottle apply the soap solution to the gas
• Turn the cylinder ON by rotating the knob to open position
- the gas connection at the inlet of the BBQ
• Using a brush or spay bottle apply the soap solution to the
- all gas hose connections
- the gas connection at the inlet of the BBQ
- the gas connection at the gas cylinder
- all gas hose connections
• If bubbles appear, there is a gas leak.
- the gas connection at the gas cylinder
• If the leak is at the connection, re-tighten and re-seal.
• If bubbles appear, there is a gas leak.
• If the leak is anywhere else or you cannot resolve the leak by t
• If the leak is at the connection, re-tighten and re-seal.
• Replace gas hose and regulator.
• If the leak is anywhere else or you cannot resolve the leak b
• Replace hose and regulators can be purchased from your loca
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your lo
2
2
Publicité
