Publicité
Audio Module Installation
1
Instalación del módulo de audio
Installation du module audio
• Select a location for mounting the audio module in a utility area or closet. The audio input jacks on the side of the module should be conveniently
accessible to plug in additional audio inputs. Secure to the wall with screws. Do not install any part of this assembly inside a wall.
• Make sure a 120 volt outlet is located near the module mounting location. Plug in the 5' power cord (supplied) after all connections are complete.
• Route the control cable from the module location to the 8GE-TSG series steam generator, or optional R80000E, 8SP-MU-4 and/or 8SP-MU-5.
The manners in which the cables are routed are dependent on what is best suited for the installation. There are multiple connection jacks in 8GE-
TSG series steam generator, two in the 8SP-MU-5, two in the R80000E, two in the 8SP-MU-4, and two on this module allowing for gangable
connections in the most convenient arrangement (See figure 3 for the system wiring diagram).
• Indicator lights, (See Figure 1):
Green Light (Power Light): This along with the blue and yellow light will flash momentarily when the power is first plugged in. This flash
indicates the microprocessor is functioning and is a test for the lights.
Yellow Light (Communication Light): This light is an indicator that the system is not communicating with the control. After the initial power
up the light will continue to flash until communication is established with the 8CH-600, 8CB-600 or 8CN-600 series control. To establish
communication, power to the 8CH-600, 8CB-600 or 8CN-600 series control must be turned on. If power is already on go to the 8CH-600,
8CB-600 or 8CN-600 series control and start a steam or shower cycle for a few seconds. Then stop or cancel the cycle. This action will
make the 8CH-600, 8CB-600 or 8CN-600 series control look for the audio system and establish communication. When the audio module is
communicating with the 8CH-600, 8CB-600 or 8CN-600 series control this light will be off.
Blue Light (Bluetooth Light): This light will be on steady when the bluetooth signal is broadcasting and not paired with a device. When a
device is paired the light will flash. The light will turn off if bluetooth is turned off on the 8CH-600, 8CB-600 or 8CN-600 series control.
• Refer to the wiring diagram on (Figure 3) for connecting the speakers to the audio control module or invisible speakers.
To reduce the risk of electric shock, do not perform any servicing other
then that contained in the operating instructions unless you are qualified
to do so.
Figure 1
Side View/Vista lateral/Vue latérale
Bluetooth antenna
Antena bluetooth
Antenne Bluetooth
Indicator lights
Luces indicadoras
Voyants
Yellow
Green
Blue
Speaker connections
Conexiones de altavoces
Connexions des haut-
parleurs
Power cord
Cable de alimentación
Cordon d'alimentation
CAUTION
!
Control cable connections
Conexiones para cables de
control
Connexions du câble de
l'appareil de commande
Audio "A" input
Entrada de audio "A"
Entrée audio « A »
Audio "B" input
Entrada de audio "B"
Entrée audio « B »
Right +/Derecha +/Droit +
Right -/Derecha -Droit -
Left -/Izquierda -/Gauche -
Left +/Izquierda +/Gauche +
2
113380 Rev. F
Publicité
