Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.11 Important advises
1.11.1 Winter services
It is important when taking the mower out of service for a longer period, to carry out the following:
-
Release tension of V-belts
-
Re-new the gearbox oil (see chapter 1.5)
-
Replace the flails if necessary
-
Check which parts have to be replaced or repaired
-
Wash and clean the machine completely, lubricate the bearings and store it in a dry place.
1.11.2 Repair
Urgent repairs and parts supplies are expensive. Why not use the winter (quite) months to bring your machine in a
"Perfect" condition for the next season.
1.11.3 Torque Moments bolt connections
Bolt connections must through, DIN 267, following list tightened, although is remarked in the manual or parts list.
Size
M8
M10
M12
M14
M16
M18
M20
1.11.4 Caution
No persons, other than the tractor driver, should be near the mower (minimum distance 100 m) whilst it is in
operation. Never walk close to the rear of the machine.
The tractor driver should never leave the tractor seat before disengaging the tractor P.T.O. shaft, stopping the
engine and pulling the tractor key out.
Never remove guards when the machine is operating.
Never touch the machine before being for 100 % sure that all parts ( P.T.O. shaft, blades, belts and pulleys)
have stopped rotating.
This machine is supplied for use in agriculture to pulverize orchard purnings, brush, corn-/ cotton-/tobacco-
stalks cutting grass in orchards, vineyards, parks, on road sides, parking lots etc.
Moment Nm, Class 8.8
Not to work on uneven and/or rocky territories.
25
50
85
135
210
290
410
15
Moment Nm, Class 10.9
35
70
120
190
300
410
570
Publicité
Chapitres
Table des Matières
