Otto QD60A-CB1B Manuel D'instructions Utilisateur page 38

Care and maintenance
In case one of the lights does not work anymore, exchange LED bulbs.
Replacing lamps
The appliance operates using a hazardous voltage. Before replacing
Electrical shock hazard!
the bulb, disconnect the mains plug. Do not touch any live
components inside the socket.
Before opening the cover and removing the bulb, allow the bulb to
Risk of burns!
cool down.
Do not touch the new bulb with your fingers, because this will reduce
Important!
the service life. Use a dry cloth.
1. Pull the plug out or disconnect the power supply using the recently installed
switch (see "Accessibility of power supply", page 9).
2. Carefully detach lamp cover.
3. Remove defective LED lamp module from plug-in connection, and replace it
by a new LED lamp module (available through our service hotline).
4. Insert lamp cover again.
5. Connect with power again.
18
General