Test Mode - Urmet 1051 Série Guide Rapide

Insert the two lithium batteries "AA" L91 in the battery compartment, taking care to observe the polarity.
4.
5. Make sure that the Tamper switch is open (released) before proceeding to the next step.
6. Within three minutes from switch-on, hold the function button pressed for 10 seconds and then release it when the red LED
and the illuminator blink once. Make sure that the learn function has been activated on the control unit.
7. After having been leant by the control unit, the detector is automatically recorded in the system. Check the control unit to
check that the learning and registration procedure were performed correctly.
8. Once learnt by the control unit, if the detector connection is lost, the LED will blink for 20 minutes to signal the fault.

Test mode

The Test mode is used to control the detection coverage of the device not the communication range with the control unit. To access
test mode, hold the function button pressed for a few seconds then release it to start the test mode that lasts for three minutes. The
detector will start initialisation during the first 30 seconds. It is advisable not to generate alarms during this time.
Motion detection in front of the detector can be checked at the end of the initialisation period. The red LED lights up for two seconds
after detection.
Mounting and installation method
The detector was designed to be mounted on a flat surface or in a corner by means of the fixing screws and the anchor bolts provided.
⚫
The package contains a metal rotation bracket to allow adjusting the camera and sensor angle. The bracket is provided
with holes for fixing to a wall or in a corner.
1. Use the installation holes on the rotation bracket to mark the corresponding points on the wall or in a corner; if necessary,
insert the anchor bolts into the wall.
2. Screw the rotation bracket in the marked installation points.
3. Screw the bracket arm onto the detector (Figure 1).
4. Clip on the detector onto the rotation bracket and adjust the detector angle with the upper holes of the bracket (Figure 2).
5. Fix the detector onto the bracket by tightening the upper screw (Figure 3).
Figure 1
Hereby, URMET S.p.A. declares that the radio equipment type: PET IMMUNE OUTDOOR DOUBLE INFRARED DETECTOR WITH
CAMERA 1051/106 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: www.urmet.com.
LINK TO ACCESS THE PRODUCT TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE). The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that
this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your
waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic
equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve
natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more
information about where you can drop off your waste equipment for recycling, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
6
Camera
installation
SIMPLIFIED EU DECLARATION OF CONFORMITY
Camera angle selection
Installation
Corner installation
holes in wall
holes
Figure 2
Corner installation holes
Figure 3
DS1051-033