Molift Mover 180 Manuel D'utilisation page 9

General safety precautions
Only use accessories and slings that are adjusted
to fit the user, type of disability, size, weight and
type of transfer.
Working pause ratio/duty Cycle.
Molift Mover 180 should not be run constantly
for more than 2 minutes (with maximum load),
and rest for minimum 18 minutes. Duty cycle
10%. (Intermittence according to standard ISO-EN
10535)
Before use / Daily check / Monthly
Inspection to be performed daily or before use:
Make sure hoist has no visible damage,
defects or deformations
Make sure sling bar connection and all detach-
able parts are properly connected and secured
Make sure battery indicator is not illuminated
and service light is green
Make sure sling strap does not have visible
damage or frays.
Make sure wheels are rolling freely and hoist is
easy to manouvre
Hand control
The hand control has 4 buttons for lifting and
lowering of lifting arm and leg spread mechanism
in and out.
The hand control has an indicator
light that will illuminate when battery level is
low and the hoist requires charging
Hand control 4 buttons
Art. no. 2018004
How to use Molift Mover 180
Safe Working Load
The hoist is marked with Safe Working Load (SWL)
Inspection to be performed monthly:
If there are any faults or defects, the lift needs to
be taken out of operation and marked "out of
order".
Lifting arm - up / down
NB! The hoist is most unstable in top position.
Legs - In / Out
NB! Spreded legs provides increased stability and
better access to chair or toilet.
9
Molift Mover 180 | BM08199 Rev C | www.etac.com
If maximum load (SWL) differs
between hoist, sling bar, and body
support unit, then the lowest maxi-
mum load shall always be used
Molift hoists shall only be used to lift
persons. Never use the hoist to lift or
move objects of any kind.
Test run hoists operation functions and make
sure hoist does not make any abnormal
sounds
Test emergency stop button and emergency
lowering