Molift Mover 180 Manuel D'utilisation page 8

Molift Mover 180 | BM08199 Rev C | www.etac.com
Charge the battery. The battery must not be in
the battery holder during assembly!
Lifting column
Place lifting column in chassis.
Lock the lift column in place by fastening the
two hexagon socket screws in front and rear of
the chassis.
Screws will ensure that the column
cannot be pulled upwards. Do not use
hoist unless the screws are mounted
correctly.
Mounting sling bar
1. Align sling bar in connection point.
2. Push button on locking pin and insert all the
way through.
3. Make sure locking pin is properly fastened
4. Push button and push bolt from opposite side
while holding in button to remove locking pin.
Assembly
Battery and hand control
1. Connect hand control to bottom of battery
holder.
2. Insert battery with terminals facing down.
3. Connect hand control wire to push handle
bracket so it does not fall to the floor when
dropped.
Checklist after assembly
Do not start using hoist before
completing control according to
checklist after assembly.
Use this checklist to verify that the hoist is properly
installed and can operate correctly and safely
before use.
Ensure that the lifting arm, lifting column and
sling bar are properly fixed and that there are
no loose parts on the hoist.
Make sure battery is charged (no lights on the
battery lamps).
Check that the hoist has no apparent damage
or other faults.
Perform one lift with load (60-80 kg)
8