Deep Cleaning - HAEGER SM-3CB.003A Mode D'emploi

Common and simple cleaning
1. Switch of the shaver and open the shaving unit by pressing the
release button on front of shaver (Fig.7)
2. Tap out excess hair shavings. (Fig.8)
3. Rinse the head of the shaver in running water. (Fig.9)
4. Close head assembly after cleaning. (Fig.10)

Deep Cleaning

Generally, the shaver head should be deeply cleaned after
using for 30 times (300 minutes); it is in favour of use life of
head and the shaving efficient.
1. Switch of the shaver and open the shaving unit by pressing the
release button on front of shaver (Fig.7).
2. Place a drop of liquid soap on the inside near each cutter.(Fig. 11)
3. Brush the soap out thoroughly with the supplied cleaning brush.
(Fig.12)
4. Turn the lock anticlockwise (Fig.13) and remove the retaining
frame Fig.14).
5. Remove and clean one shaving head a time (Fig15). Each shaving
head consists of a cutter and a guard (Fig.16).
6. Put the shaving heads back into the shaving unit and perform in
reverse steps to complete deep cleaning.
Additional remark: clean the shaver with liquid soap after
separating each component according to above steps.
Cleaning Trimmer
Lubricate the teeth of the trimmer every six month with one drop of
sewing machine oil.
User Instructions 5
English