Mounting Brackets - Revelo buggypod iO Mode D'emploi

COMPONENTS/KOMPONENTEN/COMPONENTES
H O
I
K
E G
C
IB
IP
Buggypod io box contents:
1. Buggypod io frame and seat (part IA
2. Wheel (IB)
3. Connector bar (C) and Mounting boss x 2
(G), prefitted to Buggypod
4. Mounting bracket, standard size 51, x 2 (E)
5. Mounting block x 2 (K)
6. Allen key large x 1 (H)
7. Leash (O)
8. End plug x 2 (I), pre-fitted to Buggypod
9. Hinge (IP)
10. User Guide
IA
2
1. POSITIONING THE 2. WHEN TO USE

MOUNTING BRACKETS

MOUNTING BLOCKS
140 - 375mm
The mounting brackets (e) should The mounting blocks
be fitted to two major chassis tubes (k) should be used
on the right hand side of the host when fitting the
pushchair, between 14 to 37.5 cm apart, mounting brackets
and approximately 29 to 41cm from (e) to square-shaped
the floor. tubing or thin tubing
with a diameter less
NOTE! The front bracket can be
than 18mm. They can also be used
fitted up to approx. 8 cm higher than
tohelp clear folding mechanisms if
the rear bracket if it helps provide a
the brackets interfere with folding
good connection. The Buggypod®seat
the pushchair without the block fitted.
will then tilt back slightly, as with
When fitting to square tubing, allow
pushchairs, and you may in any case
the bracket to point diagonally to the
prefer that.
rear or front so that the mounting
NOTE! The mounting brackets (e) block fits snug to the edge of
should not interfere with the braking the tubing. (see www.buggypod.com/
support_fitting.php)
system or folding mechanism of your
pushchair.
If you want to make any changes to a. Rotate the green button head of
the position of the mounting bracket, the mounting bracket so that it is
loosen the steel band screw with a vertical (or perpendicular to the
screwdriver, re-position the mounting connector bar (c) if front bracket is
bracket and re-tighten. You should try attached higher than rear bracket).
to re-position the mounting brackets b. Tighten the green button head with
if they interfere with the braking or the supplied large allen key (h)
folding mechanism of the pushchair. inserted into the hole between
the buttons.
THIS MUST BE TIGHT BEFORE USE !
3. FITTING MOUNTING
BRACKETS
Once you have identified suitable Tighten the band screw with a
locations for the mounting brackets, flat-headed or 7mm hex-headed
remove the green PVC cap from the screwdriver / spanner.
steel band tip on the mounting bracket,
turn the screw anti-clockwise to release
the bracket band from the bracket, then
wrap the steel band with the pre-fitted
black friction sleeve around the tubing
at the selected height and feed the
band tip back into the screw housing.
NOTE! Depending on the diameter of
the tubing, you should shorten the
friction sleeve with scissors so that it
does not interfere with tightening the
mounting bracket.
4. UNFOLDING BUGGYPOD®
Fold open Buggypod® by simply Press the wheel button and slide
pulling backrest and leg apart. wheel (ib) onto wheel axle until it
The two rear locks should close locks.
automatically
3