Revelo buggypod iO Mode D'emploi page 3

Fitting Check List
PLEASE READ BEFORE CONTINUING
and 3-wheelers. The mounting bracket strap can be tightened easily around most buggy
and pushchair frames. The frames can be oval, square, round, thick or thin.
attach the brackets must be vertical; otherwise the Buggypod®io will not sit vertically.
side of your pushchair (when viewed from the pushing position) between 29 - 41cm
from the floor and 14cm- 37.5cm apart.
PARALLEL FITTING
For correct installation, the mounting brackets
(Part e- see Components on page 2) need to be
positioned to allow the connector bar (c) to run
parallel to the centreline of the host pushchair.
If this is not possible, (e.g. with some 3 wheeler pushchairs),
the connector bar adaptor (d) *can be used to
ensure the connector bar is able to run parallel
to the centreline. Please see page 8 for instructions
on how to install the Buggypod®io when using the
connector bar adaptor.
using the pushchair brakes or folding the pushchair.
For more information visit www.buggypod.com
* Available seperately
1