EDM Product 31856 Manuel D'instructions page 13

▶After installation, connect the power cord of the lamp and the solar panel. Make sure the joint is fully connected to ensure the waterproof effect
of the whole (as shown in the drawing). The projector end of the conventional configuration power cord is 50cm, and the PV solar panel end is
250cm.
CONTROL REMOTO
LIGHT ON BUTTON
Press this button to light the lamp
ENHANCE BRIGHTNESS BUTTON
Press this button to make the lamp brighter
HALF BRIGHT BUTTON
Press this button to light the lamp with half of the
full power
3H MODE BUTTON
Press this button to match the brightness of the
lamp intelligently and estimate that the lamp will
be on for 3h continuously
8H MODE BUTTON
Press this button to match the brightness of the
lamp intelligently and estimate that the lamp will
be on for 8h continuously
MAINTENANCE AND CLEANING
▶ Clean the solar panel regularly to maintain good charging and light transmission to the projector. This cleaning must be done with a dry cloth.
Never use liquids.
▶Avoid storing and using the projector in corrosive environments or environments that contain harmful substances such as sulfur, halide, and
phthalate.
Instruction manual
ON OFF
+ M -
AUTO
3H 5H
8H
13
ref. 31856 -
LIGHT OFF BUTTON
Press this button to turn off the lamp
FULL POWER BUTTON
Press this button, the lamp will be on at full power
DIM BUTTON
Press this button to darken the lamp
AUTO MODE BUTTON
Press this button to enter the automatic mode to light
up, and the lamp enters the time control mode, with
100% brightness lasting for 1h, 70% brightness lasting
for 3h, and 30% brightness lasting until daybreak.
5H MODE BUTTON
Press this button to match the brightness of the lamp
intelligently and estimate that the lamp will be on for
5h continuously
31860
ES
PT
EN
FR