ZEN AROME Zen'Light Mode D'emploi page 8

Exploded view of the pump
(Representation of all parts of a pump)
ASSEMBLY AND USE INSTRUCTIONS FOR ALL OUR FOUNTAINS EXCEPT THE XL ONES:
1. Install the lighting in the decorative part of the fountain. To do this, here are the different installations according to the model:
• For pump with 1 LED ring: Insert the ring around the pipe present in the fountain and slide the ring to the top.
• For pump with 1, 2 or 3 LED spots: insert the spot(s) in the hole(s) provided inside the decorative part (top part). Simply insert them into the small
rubber tube(s) in the cavity(s).
• For pump with 1 LED ring and 1 LED spot: see ring and spotlight installation above.
• For pump with connector: Make the connection of lighting element to the power source via the connector provided, and screw the cover tightly to
make it waterproof.
2. Insert the pump's output connector ("Connecteur de sortie" in Exploded view) to the hose in the fountain. Fill the tank with demineralized water to a
level sufficient for the pump to be completely submerged, this is essential for your pump to be silent when operating.
3. It is possible to adjust the water flow by operating the slider located on the front of the pump. For models with a glass ball, make sure the regulator
support (Support régulateur) is set to the "+" position so that the ball can turn.
4. Place the decorative part on the tank with the pump power cord running to the back of the fountain. Position the glass ball on its location (this is only for
models with a glass ball).
5. Make sure the pump is fully immersed in the water.
6. Plug the power cord into an electrical outlet, making sure the components are free of moisture. Dry your hands well before handling. For models with a
USB pump, use a compatible adapter: OUTPUT 5V - 1A.
MAINTENANCE:
If you notice any impurities in the water, disconnect the pump from the electrical outlet
before any intervention, then change the water and clean the pump.
For a complete cleaning of pump, remove the protective grille (Grille de protection) and the
regulator support (Support Régulateur) to access the propeller (Hélice) see exploded view. Clean
each component with a cloth or cotton swab and reassemble.
If your pump makes noise during operation, please check that
- if the pump is completely immersed in water and add water.
- if the pump is not touching the edge of the fountain and move the pump to the center of the
tank or slightly away from the edge.
- Make sure the pump is clean and proceed a thorough cleaning as described above.
EN