ZEN AROME Zen'Light Mode D'emploi page 5

WE THANK YOU FOR CHOOSING OUR ZEN'LIGHT FOUNTAIN. PLEASE READ ALL INSTRUCTIONS BEFORE USING YOUR FUNTAIN, ESPECIALLY THESE ESSENTIAL
SAFETY GUIDELINES. FAILURE TO FOLLOW THE INSTRUCTIONS COULD LEAD TO A RISK OF FIRE. KEEP THIS MANUAL FOR FUTURE REFERENCE.
BEFORE ANY USE, IT IS IMPORTANT TO KNOW THAT NO MODIFICATIONS CAN BE MADE TO THE PRODUCT. ONLY THE CABLE AND PUMP PROVIDED WITH THE
PRODUCT SHOULD BE USED.
Our fountains are designed and manufactured in accordance with European standards and guidelines, with a maximum immersion depth of one meter. The
temperature of the water used should not exceed 30°C.
The pump model may vary depending on the fountain model. Please refer to the information indicated on the pump of your fountain. Here are the
characteristics of the pumps used:
JN-200LED: 220-240V, 50-60Hz, 3W, IPX8, CLASSE II
JN-300LED: 220-240V, 50-60Hz, 3W, IPX8, CLASSE II
JN-333LED: 220-240V, 50-60Hz, 5W, IPX8, CLASSE II
JN-355LED: 220-240V, 50-60Hz, 5W, IPX8, CLASSE II
JR-800LV : AC12V, 50Hz, 17W, IPX8, CLASSE II. Adaptor: Input 220-240 V, 50 Hz, IP44 ou IP67, Output 12V,1800mA.
JN-1020: 5V -0.12A, 120mA, IPX8, CLASS II. Adaptor: Input 100-240V, 50-60Hz, 0.15A
*IPX8: Protected against prolonged immersion in water up to a maximum depth of 1 meter.
*IP44 / IP67: Protected against solid objects greater than 1 millimeter. Protected against small splashes of water from all directions.
To ensure optimal use of your fountain, we recommend following the following precautions:
1. Use only demineralized water and replace it every three days (if the device is used daily) to avoid any alteration due to limescale or deposit formation.
This fountain is intended for exclusive indoor use and should be installed in an environment between 10°C and 30°C. The water temperature used
should be between 10°C and 30°C.
2. Connect the fountain to the power supply only after assembly and water filling are completed.
3. Before using your fountain, ensure that the voltage of your power supply matches that of the device, refer to the list mentioned below. Electrical
hazard warning.
4. Water evaporates more quickly in small fountains than in large ones. Check the water level after 8 hours of use.
5. Before the first frost, empty and vacuum the water from the fountain.
6. If the pump does not work when plugged into a socket, unplug it and proceed with maintenance. Please refer to the explanations below for
instructions. If the pump cannot be repaired, it should be destroyed.
7. Do not turn on the fountain when the reservoir is empty. Empty the reservoir when the device is not in use and do not let stagnant water remain for
Indoor fountain Zen'Light
Instructions for use
EN