KW Hydraulik BDL041 Manuel D'utilisation page 20

English
Pull the spring and slide the
head of the tool.
Push the hydraulic head completely to the stop check that the
spring locks correctly the head.
CHECK THAT THE SPRING IS CORRECTLY IN THE
NOTCH OF THE HEAD.
Slide the battery all the way into the
tool until lock clicks.
0215 - BDL041 - 20
The moveable handle can be screwed on 2 sides of the head
DO NOT USE THIS TOOL ON LIVE CABLES
USING THE TOOL
Spot the kink on the contact wire.
Fit only head of the kink-remover over the contact wire (the
chain should be in front of you).
Center the head with respect to the kink.
In case of strong curvature of contact wire (on 150mm²
contact wire for example), place the curvature of the contact
wire in opposition to the curvature the die of the tool.
Press the button ON/OFF tool. The LED light
up (see INDICATIONS LED).