Style 2 - Undermount Sinks - KitchenAid W10176364 Instructions D'installation Et Guide D'utilisation Et D'entretien

3. Install all clamps to their mount positions with screws (not
supplied).
A. Clamps
B. Sink
4. Begin tightening clamps without overtightening them. It is
necessary only to draw the sink rim down firmly to the
countertop. Tighten until the entire sink rim is sealed.
B
A
E
A. Countertop
B. Clamp screws
C. Clamp
D. Countertop screws (not provided)
E. Cabinet supports
F. Sink
G. Cabinet front
5. Wipe off any excess sealant from the countertop with a dry
cloth.

Style 2 - Undermount Sinks

Cutout Countertop:
1. Locate template in sink package.
NOTE: If no template is provided, contact KitchenAid™. See
"Assistance or Service" section.
2. Cut template out for desired undermount installation.
Tape template in desired position on the underside of
countertop surface.
Trace around the template for sink cutout and drill holes.
3. Use drill bit size according to hardware manufacturer's
mounting requirements to drill holes for screws (not provided).
4. Remove the template.
4
A
B
D
C
G
F
5. Cut out countertop by using the 1³⁄₁₆" router guide bushing
and the ¹⁄₂" straight cutter bit.
If using a router, make a ¹⁄₂" thick plywood template using
the supplied paper template.
6. Finish cutout edge of countertop with desired finishing
techniques.
Install Undermount Sink:
1. Clean flange, rim of sink and countertop mating surface
(underside of countertop) with solvent such as denatured
alcohol.
2. Generously apply a continuous silicone bead around the sink
®
rim. (Dow Corning 786 is recommended.)
3. Align sink to underside of countertop cutout so that a uniform
sink edge is visible from the top side of the countertop around
the periphery of the cutout.
IMPORTANT: You cannot make any adjustments after
performing the following step.
4. Install all clamps to their mount positions with screws (not
provided).
A. Clamps
B. Sink
5. Begin tightening clamps making sure not to overtighten. It is
necessary only to push the sink rim up firmly to the
countertop. Tighten until the entire sink rim is sealed.
A
B
D
A. Countertop
B. Screws
C. Clamp
D. Cabinet supports
E. Sink
F. Cabinet front
6. Wipe off any excess sealant from area with a dry cloth.
A
B
C
E
F