Original Prusa XL Mode D'emploi page 57

ÉTAPE 20 Nozzle seal heigh calibration
Starting in May 2024, you may receive a gray nozzle seal. The assembly and
functionality remain identical to the red one.
The following image was made with the Nextruder and dock removed from the
printer for better visibility of how it should be set. Please do not remove the docks
from the printer and set the seal height with the dock still connected to the
printer.
In the next step, we'll calibrate the height of the nozzle seal.
Using the 2.5 mm Allen key, tighten or untighten the M3x30 screw to calibrate the
height of the nozzle seal.
Proceed to the next step.
ÉTAPE 21 Nozzle seal heigh calibration
If is the Nozzle seal too low or too high, we need to reposition its height.
Using a 2.5 mm Allen key:
Turn the M3x30 screw clockwise to set the Nozzle seal lower.
Turn the M3x30 screw counterclockwise to set the Nozzle seal higher.
The correct position of the nozzle seal is when it isn't bent and is touching the
nozzle.
Mise à niveau de l'Original Prusa XL Mono-outil vers Double-tête
6. Assemblage du Nextruder & des accessoires
57