Chapin Tree/Turf Pro Manuel D'utilisation Et D'entretien page 4

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining
Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle hole and shaft hole. Slide the bolt (B) through
the aligned hole as shown in figure 3. Tighten nut (D) to bolt. There are
holes in the pump handle to allow for either left (fig.2-4) or right (fig.5)
hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
INSTALLING THE SHOULDER STRAP
The backpack strap is provided with
multiple features including shoulder
strap, chest strap, waist belt and lumbar
support. (figure 1). The top the shoulder
strap is attached to the top of the tank
and is removable. The hook from the
lumbar support attaches to the base tube
on the bottom of the tank (figure 2).
Wand O-ring
Pump Handle
Pump Shaft
Figure 2
Line up holes
Figure 5
Right Hand
Figure 1
Strap Assembly
3E
Shut-off
Valve
A. Pump Shaft
D. Nut
C. Pump Handle
Figure 3
Slide bolt through holes
Hook
Shoulder
Strap
Chest
Strap
Lumbar
Support
Waist
Figure 2
Belt
Hook Attachment
B. Bolt
Lumbar
Support
Base
Tube