TP-Link EAP660 HD V2 Guide D'installation page 9

If your Ethernet cable feeds through the wall, position the
1
mounting bracket and feed the Ethernet cable� Mark positions
for the screw holes and then drill 6 mm diameter holes at the
marked positions�
2
Insert the plastic wall anchors into the 6 mm diameter holes�
Secure the mounting bracket to the wall by driving the self-
3
tapping screws into the anchors� Make sure that the shoulders
of the mounting bracket are on the outside�
4
Connect the Ethernet cable to the Ethernet port on the AP�
Attach the AP to the mounting bracket by aligning the arrow
5
mark on the AP with the arrow mark on the mounting bracket,
then rotate the AP until it is locked into place�
7
English