Publicité
Les langues disponibles
Les langues disponibles
Using the webslings for any purposes other than the purposes they have been designed for, using them
under extremely dangerous conditions and performing poor maintenance may pose a severe hazard
to the safety of the people being exposed and cause severe damage to the working environment, while
affecting the actual serviceability and safety of the product. The precautions mentioned below, which,
obviously enough, cannot cover the whole spectrum of potential "misuses" of the accessory, should
be "reasonably" deemed to be the most common steps to take. Therefore:
• DO NOT connect the slings to any apparatus which does not match their specifications
in terms of size, temperature, hook-up point and shape;
• DO NOT apply loads exceeding the carrying capacity of the sling;
• DO NOT use polyester slings to lift edged or pointed loads;
• DO NOT use unreliable and/or poorly identified slings;
• DO NOT attempt to restitch or mend any slings;
• DO NOT lift the load while subjecting the accessory to impulsive strain;
• DO NOT let the load swing while handling it;
• DO NOT use the accessory to lift and carry suspended loads in flight (aircrafts);
• DO NOT use the slings to pull restrained loads;
• DO NOT stretch any apparatus that may change its static configuration, centre of gravity
or chemical and physical state;
•
DO NOT use the accessory to lift or carry people or animals; in case of use the
accessory as a component in machinery for lifting people or animals, safety coefficients
shall be increased by a competent technician, in accordance to the
directive 2006/42/CE, attachment I, par. 6.
• DO NOT connect the slings to each other through knots to extend them;
• DO NOT shorten the slings through knots; a 50% reduction in strength might occur;
• DO NOT use any slings immersed in acid solutions or in the presence of acid vapours;
• DO NOT leave the slings on the ground, to prevent any vehicle wheels or tracks from
running on them.
The accessory was subjected to spot check in order to test serviceability and performance at the
manufacturer's. The certificate supplied with it states that the tests under the relevant standards were
passed. However, before starting working, the user should test the installed accessory for serviceability
and performance, to prove the entire system is fit for use.
Division of BETA UTENSILI SPA, Via Volta, 18 - 20845 SOVICO (MB) ITALY Tel. +39.(0)39.20771-Fax + 39.(0)39.2010742
10)
NONPERMISSIBLE USE
11)
FITNESS FOR USE
12/13
Publicité
