Wiring
Standard
1. Use illustration for proper connection and be sure to maintain speaker
Installation/
System Setup
·!Ius
-:u
polarity.
2. Use only "TWEETER" input(s).
Example of T1 Component
Standard/Bi·Amp Wiring
Default Setting
,
........... ..
,
'
I
81-AMP
"
Bi-amp
1. Use illustration for proper connection and be sure to
maintain speaker polarity.
1
t0FF,
r-ON',
...........................
\~
.. EJ,f
Standard Mode
-
.. , ..
-
.
.
2.
Remove 4 screws from crossover bottom to detatch cover.
3. When BI-AMP switched OFF for one amplifier, use only
"TWT" input.
4. When BI-AMP switched ON for two dedicated amplifier,
use both "TWT" and "WFR" inputs
Remove 4 screws from
~
bottom to detatch cover
#
T1T-S Crossover
1. Use illustration for proper connection.
2. Be sure to maintain speaker polarity.
..........
3. Connecting the positive wire to OdB matches the amplitude of the
tweeter to the mid-range (woofer).
4. Connecting positive wire to -2dB or -4dB to reduce the amplitude of
the tweeter -2dB or -4dB lower than the mid-range, (ideal for tweeters
located high in door panels and mid-range low in the kick
panel).
Tweeter On-Axis
Tweeter Off-Axis
f
-
i!iUS.AA3,2
Example of TH·S wiring
........
.
...................................
. .
.
(TWT)
Tweeter ON/OFF Axis Switch
Tweeter
(TWT)
Tweeter
(TWT)
1. Set to ON or OFF to
match
position of tweeter relative to listener.
Default OFF position satisfies most installations.
Tweeter Attenuation Switch
1. OdB matches the amplitude (no increase/no attenuation) of the tweeter
to the same level as the mid-range (woofer).
2. +2dB increases and -2dB reduces the amplitude of tweeter in relation
to the mid-range, (ideal when matching offset installation like tweeters
located high in door panels and mid ranges low in kick panels).
Tweeter
On-Axis
Twee te
r Off-Axis
i!ius.-
41
Example of T1 component
tweeter setup
'
.............................................. ..
(J.L
. . ,
Ax
i ss•tJI;
....
,. ..
..
-~
..
..............................
,
. . .
..
....... .
. .
.
.
.
.
.
.
.
. .
7