Power Dynamics PD ComboSet Serie Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. SUBWOOFER VOLUME: Control the volume level of the subwoofer.
2. SATELLITE VOLUME: Control the volume level of the satellite speakers.
3. COMBO JACKS LINE IN: Balanced stereo inputs with combo connectors.
Use standard XLR or 6.3 mm jack cables to connect audio units with line
level output (e.g. mixers or preamplifiers) to these inputs. When connecting a
mono device, only use the left jack and depress the mono/stereo switch.
4. XLR LINE OUTPUTS: Balanced XLR jacks, connected in parallel to the
inputs, to connect another device, e.g. a further active speaker system.
5. BT PAIR BUTTON: Push to set up pairing with BT-capable devices.
6. RCA LINE INPUT: Additional stereo input on unbalanced RCA jacks. Use a
standard stereo RCA cable to connect a line-level device to this input. Use
the SENSITIVITY switch to adjust the input level for the signal source.
7. DSP PRESET: Choose between Monitor, DJ and Live.
8. MONO/STEREO: Switch between mono and stereo.
9. SENSITIVITY SWITCH: To match the level for units with a low output level at
the RCA inputs. With the button engaged, the input level is boosted by 5 dB.
10. SPEAKER CONNECTORS: High-pass filtered speaker jacks for connecting
the left and right satellite speaker.
11. POWER SWITCH: Switch to turn the device ON or OFF.
12. AC IN AND FUSE HOLDER: Socket for plugging in the supplied power cord.
CONNECTING WITH BT
1.
2.
3.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "BT" button and activate BT-function.
Select "PD COMBOSET" on your BT-device and make the BT-connection
4