Publicité
Calibrating
Please wait
Throttle
This flight mode requires low
throttle before starting motors
6.1.2
Alertes de service
Les alertes suivantes indiquent une erreur système qui nécessite un entretien. Utilisez l'application pour soumettre
Uneven
un billet de dépannage à 3DR Support ou contactez un centre de service Solo agréé pour effectuer l'entretien du
Move Solo to a level surface
Solo et résoudre l'alerte. Une erreur de joystick peut se produire en vol ou avant le décollage. Quand l'erreur de
joystick est reçue en vol, le Solo rentre à la base et atterrit.
Service
Use 3DR Solo app to log a trouble
ticket with customer support
6.2
Erreurs en vol
Pendant le vol, la manette surveille le signal GPS du Solo, le signal de la manette, le niveau de batterie de vol et le
niveau de batterie de la manette.
6.2.1
Limite d'altitude
Quand Solo atteint la limite d'altitude pendant le vol, il maintiendra et ne dépassera pas cette altitude ; en outre,
la manette affiche l'alerte suivante.
6.2.2
Connexion d'application
La manette affichera les alertes suivantes sous la forme d'une bannière en cas de connexion ou déconnexion de
l'application Solo du Solo. Une connexion active permanente au Solo est recommandée pendant le vol. Référez-
vous à la section 2.6 pour se connecter au réseau Wi-Fi du Solo via l'application. Le Solo ne retourne pas à la base
si la connexion à l'application est perdue pendant le vol.
Alert persists until:
All manuals and user guides at all-guides.com
User completes calibration using the app (system then continues sensor check)
User powers off controller, or Solo
compass
Controller auto-shutdown
Compass
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
ARMING ALERTS
Please calibrate compass using
the 3DR Solo app
Compass error
User asked to use Solo app to calibrate.
Alert persists until:
User completes calibration using the app (sys then continues sensor check)
Calibration
error
Powers off controller, or Solo
too high
Please restart Solo
Controller auto-shutdown
Level
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Please calibrate level
using the 3DR Solo app
Figure 6.1.1.4: Manette - Alerte d'erreur de calibrage
Level error
User is asked to use Solo app to calibrate
Alert persists until:
User complete calibration using the app (sys then continues sensor check)
Calibrating
Solo
Powers off controller, or Solo
Please wait
surface
Controller auto-shutdown
Sensor
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Please try and restart Solo
Catch-All
Remaining rare but problematic APM errors
will be captured under a catch-all for
logging trouble tickets
Calibrating
compass
Please wait
required
Control stick
Contact 3DR customer support
Figure 6.1.2.1: Manette - Alertes de service
Throttle
too high
This flight mode requires low
Unknown
throttle before starting motors
Battery % not be accurate
Dismiss
Uneven
surface
IN-FLIGHT ALERTS
Move Solo to a level surface
Maximum
Preset max altitude reached
Service
required
Use 3DR Solo app to log a trouble
Figure 6.2.1.1: Manette - Alerte de limite d'altitude
ticket with customer support
Crash
detected
Press
GPS
Switching to manual control
Compass error
User asked to use Solo app to calibrate.
Level
error
Alert persists until:
User completes calibration using the app (sys then continues sensor check)
Please calibrate level
using the 3DR Solo app
Powers off controller, or Solo
error
Controller auto-shutdown
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Altitude calibration
System self-calibrates altitude after altitude disparity
Alert persists until:
Level error
System self-calibrates (sys then continues sensor check)
User is asked to use Solo app to calibrate
Timeout: after 1 minute (?) (results in "sensor error" screen)
Alert persists until:
Sensor
error
User complete calibration using the app (sys then continues sensor check)
Please try and restart Solo
Powers off controller, or Solo
error
Controller auto-shutdown
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Altitude calibration
System self-calibrates altitude after altitude disparity
Alert persists until:
Sensor error screen
System self-calibrates (sys then continues sensor check)
For sensor errors requiring user-initiated restart
Timeout: after 1 minute (?) (results in "sensor error" screen)
Control stick
error
Contact 3DR customer support
error
IN-FLIGHT ALERTS: CONTROLLER RELATED
Compass error
User is asked to use Solo app to calibrate.
Alert persists until:
Control sticl error
?
User completes calibration using the app (system then continues sensor check)
Persists until:
Unknown
battery
User powers off controller, or Solo
Controller starts with stick values in range.
Controller auto-shutdown
Battery % not be accurate
Note: Artoo will not assume the same error is present on
Control stick
Control stick
error
restart, and will run a fresh check when connected to Solo.
Dismiss
Solo will return home
Solo will return home
Compass error
User asked to use Solo app to calibrate.
Battery unknown
Alert persists until:
Displayed if Artoo is powered on with a battery has an
ID resistor unknown to Artoo. (Not logged in current software version's index.)
User completes calibration using the app (sys then continues sensor check)
HAPTIC: Strong feedback, 40 millisecond pulse
Powers off controller, or Solo
?
After Solo is disconnected, Artoo should display "waiting for Solo"
Controller auto-shutdown
Controller
Note: Artoo will not assume the same error is present on
battery
restart, and will run a fresh check when connected to Solo.
Solo will return home
Level error
User is asked to use Solo app to calibrate
Alert persists until:
User complete calibration using the app (sys then continues sensor check)
Powers off controller, or Solo
Controller auto-shutdown
Signal
recovered
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Maximum Altitude
User is told that maximum altitude has been reached
Vehicle is not able to go higher than max altitude
Alert appears once per flight and is triggered at 100 FT by default.
Catch-All
Alert persists until:
Remaining rare but problematic APM errors
altitude
TIMEOUT: 5000 milliseconds
will be captured under a catch-all for
logging trouble tickets
HAPTIC: Double buzz 40-40 millisecond
Controller
Emergency landing started
Crash Detected
User can use app to log a support ticket
Alert persists until:
User presses A
HAPTIC: Quad buzz: 40-40-40-40
Solo SFX: Start lost call ping if more than 10 m away
to dismiss
GPS signal lost (Switches to FLY: Manual)
Alert persists until:
TIMEOUT: 3000 milliseconds
HAPTIC: Triple buzz twice: 30-30-30, 30-30-30
lost
12
FLIGHT BATTERY
User complete calibration using the app (sys then continues sensor check)
Powers off controller, or Solo
Controller auto-shutdown
Note: Artoo will not assume the same error is present on
restart, and will run a fresh check when connected to Solo.
Sensor error screen
For sensor errors requiring user-initiated restart
Control sticl error
Persists until:
Controller starts with stick values in range.
Battery unknown
Displayed if Artoo is powered on with a battery has an
ID resistor unknown to Artoo. (Not logged in current software version's index.)
HAPTIC: Strong feedback, 40 millisecond pulse
Controller Value out of Range
After Solo is disconnected, Artoo should display "waiting for Solo"
User is asked to contact customer support
Alert persists until:
TIMEOUT: 5000 milliseconds
go to persistent hint-box message
error
error
(persistent until reboot)
RC Failsafe
Controller signal lost, RTH screen
Alert persists until:
TIMEOUT: 5000 milliseconds
signal lost
RC Signal Recovered
User can press Fly to recover
Alert persists until:
User presses Fly and enters Fly mode
HAPTIC: 40millisecond so user is aware that they can take control
RC Failsafe (No GPS)
Controller signal lost,
emergency land screen
Alert persists until:
TIMEOUT: 5000 milliseconds
signal lost
FLY
Camera paddle and dial failure
Alert triggered on input error on the paddle
HOME
or tilt speed dial potentiometers
324
FT
TIMEOUT: 5000 milliseconds
ALTITUDE
12
Return
FLIGHT BATTERY
48
%
Contro
Contact 3DR Su
33
Publicité
